Lab 4.2.3.2 Designing and Applying an IP Addressing Scheme

 

Device Name Enable Secret Password Enable, Console, and vty Passwords IP Address Subnet

Mask

Default Gateway
Switch1 class cisco VLAN 1: 192.168.1.34 255.255.255.224 (/27) 192.168.1.33
Switch2 class cisco VLAN 1: 192.168.1.66 255.255.255.224 (/27) 192.168.1.65
Router1 class cisco FA0/0: 192.168.1.33

FA0/1: 192.168.1.65

255.255.255.224 (/27) N/A
Host1 N/A N/A 192.168.1.35 255.255.255.224 (/27) 192.168.1.33
Host2 N/A N/A 192.168.1.67 255.255.255.224 (/27) 192.168.1.65

 

Step 1: Cable the network

a. Connect Host1 to Switch1 port Fa0/2, using a straight-through Ethernet cable.

b. Connect Host2 to Switch2 port Fa0/2, using a straight-through Ethernet cable.

c. Connect Switch1 port Fa0/1 to Router1 port Fa0/0, using a straight-through Ethernet cable.

d. Connect Switch2 port Fa0/1 to Router1 port Fa0/1, using a straight-through Ethernet cable.

 

 

 

 

 

Step 2: Configure the router

a. Establish a terminal emulation session from either host to Router1.

b. Configure the router hostname, passwords, interface IP addresses, and subnet mask. Also configure RIP as the routing protocol.

c. Save the configuration.

 

 

 

 

 

 

 

 

 

 

 

 

 

Step 3: Configure the switches

a. Establish a terminal emulation session to Switch1 from Host1.

b. Configure the switch hostname, passwords, interface VLAN 1 IP address, subnet mask, and default gateway on Switch1.

c. Save the configuration

 

 

 

 

 

 

 

d. Establish a terminal emulation session to Switch2 from Host2.

e. Configure the switch hostname, passwords, interface VLAN 1 IP address, subnet mask, and default gateway on Switch2.

f. Save the configuration.

 

 

 

 

 

 

Step 4: Configure the hosts

  1. Configure Host1 using the IP address, subnet mask, and default gateway from the table.

 

 

 

 

 

 

 

 

b. Configure Host2 using the IP address, subnet mask, and default gateway from the table.

 

 

 

Step 5: Verify connectivity

To verify that the network is set up successfully, ping from Host 1 to Host 2.

Was the ping successful?  Sukses

If the ping is not successful, verify the connections and configurations again. Check to ensure that all cables are correct and that connections are seated.

 

 

 

Step 6: Reflection

Subnetting allows the addresses in a network range to be split into smaller groups. This lab split the total number of addresses, 256, into smaller groups of equal size.

–       How many address are in each subnet?

Alamat subnet yang akan terbentuk disetiap subnet adalah 30 buah

–       How may total subnets were created?

Total subnet yang terbentuk 2 3 = 8 buah

–       The subnet mask is 255.255.255.224. How many host bits were “borrowed” for subnetting? Bit yang dipinjam untuk subnetting adalah 3 buah

–       What is the total number of network and subnet bits in each address?

Total network 27 network dan 19 buah subnet bit